説明
Soft plastic PVC galvanized plastic electroplating car window rearview mirror door side bumper body door trim strip anti-collision protection strip
The section is thick in the middle and thin on both sides (radian surface), the middle thickness is about 2 mm
Installation Notes
1. Thoroughly clean the place where the car body needs to be pasted. If there is oil or wax, wipe it off with alcohol.
2. After tearing off the protective film on the back of the bright strip, stick it carefully, and then subtract the excess.
3. If the temperature is below 20 degrees, it is recommended to bake the adhesive with electric hot air before sticking to get good results. Do not wash the car within 1 day after sticking.
Front window---length: 3-3.2m, width 2cm
Rear window---length: 2.8-3m, width 2cm
Rearview mirror---length: 0.3m, width 1cm
Door side---length: 1m, width 1cm
Upper light eyebrow---length: 1m, width 1cm
Lower light eyebrow---length: 1m, width 1.5cm
Four corners---length: 2m, width 1-2cm
Front car circumference---length: 2.6-3m, width 1-2cm
Rear car circumference---length: 2.8-3.2m, width 1.5-2cm
Due to different models, the data is for reference only, and your measurement shall prevail
-
Fruugo ID:
372808567-807414071
製品安全情報
以下に概説するこの製品に固有の製品安全性情報を参照してください。
以下の情報は、この製品を販売する独立したサードパーティ小売業者によって提供されています。
製品安全ラベル
安全上の警告:
important Safety Instructions Read Before Use: Please read all instructions and safety warnings before using this product. Failure to follow these guidelines may result in injury, damage, or malfunction. General Warnings Intended Use: Use this product only for its intended purpose as described in the user manual. Supervision Required: This product is not intended for use by children or persons with reduced physical, sensory, or mental capabilities without supervision. Inspection Before Use: Check for any signs of damage or wear before use. Do not use if damaged. Usage Precautions Environment: Do not use in wet, damp, or flammable environments unless specified as safe for such conditions. Proper Operation: Follow all operating instructions carefully. Avoid improper handling or misuse. Power Source: Use only the recommended power supply or batteries. Do not exceed specified voltage or current ratings. Maintenance and Care Cleaning: Disconnect from power before cleaning. Use only manufacturer-recommended cleaning methods and solutions. Storage: Store in a cool, dry place away from direct sunlight and extreme temperatures. Repairs: Do not attempt to disassemble or repair the product. Contact authorized service personnel for assistance. Specific Warnings Avoid Hazards: Keep the product away from sharp objects, water, and heat sources. In Case of Malfunction: If the product malfunctions or exhibits unusual behavior, discontinue use immediately and contact customer support. Disposal Instructions Recycling: Dispose of the product in accordance with local electronic waste disposal and recycling guidelines. Battery Disposal: Follow specific regulations for the safe disposal of batteries if included.
