Specifications:Working voltage: 80 260VACTest voltage: 80 260VACRated power: 100A22000WOperating frequency: 45-65HzMeasurement accuracy: 1.0 gradeFeatrues:1.Electrical parameter measurement function voltage, current, active power, energy, frequency, power factor2.Overload alarm function over power alarm threshold, backlight and power flashing to alarm.3.Power alarm threshold preset function can set power alarm threshold.4.The energy can be reset use the key.5.Store data when power off.6.Large-screen LCD7.Backlight function.Short press the key to turn on or off the backlight, the backlight has memory function, it can store the on or off state when power off.Display: Large-screen LCD, it can display six parameters at the same time.Display format:1.Power: test range: 022000W, Starting measure power: 0.2W10W display format: 1.009.99W100W display format: 10.099.9W1000W display format: 100999W10000W display format: 1.009.90kW10000W display format: 10.022.0kW2.Energy: test range: 0999kWh1kWh display format: 0999Wh10kWh display format: 1.009.99kWh10kWh display format: 10999kWh3.Voltage: test range: 80260VDisplay format: 80260V4.Current: test range: 0100A,Starting measure current: 0.001A10A display format:0.0009.000A10A display format:10.0099.99A5.Frequency: test range: 4565HzDisplay format: 4565Hz6.Power factor: test range: 01PFDisplay format: 0.001.00PFKeys Function1.Backlight controlShort press the key to turn on or off the backlight, the backlight has memory function, it can store the on or off state when power off.2.Reset energyStep1: Long press the key for 5 seconds until the energy value flash, then release the key.Step2: Short press the key again, then the energy value is cleared and exit the reset flashing state.Step3: If there is no operation on the key within 5 seconds, it means the energy value is not cleared and will exit the reset state.3.Set power alarm thresholdStep1: Long press the key until the LCD screen display 'SET CLr', then release the key to enter the setting stateStep2: Power window display the current power alarm value and the last digit begin to flash, then you can short press to plus 1, when there is no operating over 3 seconds, it will switch the digit position automatically, the setting method is as same as the above.Step3: After finish the setting, long press the key over 5 seconds will store automatically and exit, the range of active power threshold is 0.022kW.4.PrecautionsThis module is suitable for indoor, please do not use outdoor.Applied load should not exceed the rated power.Wiring order can't be wrong.Package List:1 x Digital Power Meter1 x Closed CT Note: Due to the light and screen setting difference, the item's color may be slightly different from the pictures. Please allow slight dimension difference due to different manual measurement.