describe:1: This air plunger for toilet has a non-slip ABS plastic handle and high-quality stainless steel shell, so there is no need to worry about deformation or rust.2: The toilet plunger uses the power of high-pressure compressed air (up to 8PSI) to blow out blockages in pipes in seconds. Use the inflatable base to inflate it once and it can be reused. Faster and more efficient than traditional plungers, toilet snakes and toilet augers!3: The air pressure indicator is designed upward. It is easier to observe when pumping, the quality is stable and durable. The professional and precise instrument panel can accurately control pneumatic activities and operating forces, display pressure in real time, adapt to different dredging requirements, and avoid splashing and damage caused by excessive force. It is a truly user-friendly design. Note: If you notice no change in the pressure gauge while filling, check the seal to make sure it is seated tightly in the groove.4: Suitable for all occasions, such as toilets, squat toilets, kitchens, sinks, washbasins, etc. Suitable for all kinds of pipes. It can handle various clogs caused by various waste products such as hair, fabric, tea, leaves, grease, oil and dirt. With high-pressure air power, it clears gutters quickly and easily. Ideal for use with sinks, tubs and toilets.5: When using, first cover the opening of the sink or toilet with plastic wrap, leaving only a gap, and you can put the drainage unblocker in, without worrying about splashing water. After use, simply peel off the plastic wrap and rinse the drain clearer with water.Specification:Material: ABS+stainless steelSize: 66CMpacking list:1* Stainless steel toilet pipe unclogger1* Toilet unclogging head1* Clean the sink unclog head1* Sink or floor drain plug1* converter1* Inflatable foot padInstructions:first step:Before use, appropriate suction cup installation products should be selected based on the size of the blocked pipe.Step two:After the suction cup is installed, hold the handle, pull the pump rod, and complete the full stroke several times, about 15-25 times. After the air cannot be pumped in and high-pressure gas is obtained, the air tank can be inflated.third step:Block the pipe outlet and seal it; pull the trigger to release high-pressure gas.the fourth step:This can be repeated if the first attempt fails.