["Description:\nbrand new and high quality\nFeature:\nIt adopts high current relay, has greater load power, and more stable performance.\nThe receiver uses the high-sensitivity receiving module, has better anti-interference ability.\nComes with the external antenna, greatly enhance the receiving distance.\nEasy and simple to install and remove.\nCan be widely used in water pump and other fields.\n\nSpecifications:\nItem Type: Receiver+Remote Control\nMaterial: ABS+Metal\nSize: receiver: 56x110x34mm/2.2x4.3x1.3in, remote control: 61x29x12mm/2.4x1.1x0.4in\nColor: White+Black\nVoltage: DC12-48V\nWorking Frequency: 433MHz\nLoad power: 10A\nMax load: 1200W\nWorking mode: jog, interlock, self-lock, delay\nRemote control distance: 200-1000m(for depend on the remote control and using environment)\nApplicable field: for water pump\nQuantity: 1 Set\n\nInstructions:\nLearning function:\nJog Mode: Long press the learning for key for 3 seconds to enter the learning status. After the red light is for always on, press the remote control for key at once; When the indicator light flashes quickly and goes out, then the learning of \"jog\" mode is successful.\nInterlock Mode: Long press the learning for key for 3 seconds to enter the learning status. After the red light is for always on, press the \"A\" for key of the remote control once to open it. After the red light flashes twice and is for always on, then press the \"B\" for key of the remote control to close it. When the red light flashes quickly and goes out, then the learning of \"interlock\" mode is successful.\nSelf-lock Mode: Long press the learning for key twice to enter the learning status. After the red light is for always on, press the for key of the remote control; if the indicator light flashes quickly and goes out, then the learning of \"self-lock\" mode is successful.\nManual function:\nPress the for key and the relay will start working, the red light will be for always on; then press the for key once again, the relay will turn off and the red light will be for always off.\nDelay function:\ndelay 5S: Short press the learning for key three times, when the red light is for always on, then press the for key of the remote control. If the indicator light flashes quickly and goes out, then the learning of \"delay 5S\" mode is successful.\ndelay 10S: Short press the learning for key four times, when the red light is for always on, then press the for key of the remote control. If the indicator light flashes quickly and goes out, then the learning of \"delay 10S\" mode is successful.\ndelay 15S: Short press the learning for key five times, when the red light is for always on, then press the for key of the remote control. If the indicator light flashes quickly and goes out, then the learning of \"delay 15S\" mode is successful.\ndelay 20S: Short press the learning for key six times, when the red light is for always on, then press the for key of the remote control. If the indicator light flashes quickly and goes out, then the learning of \"delay 20S\" mode is successful.\nClear code operation:\nLong press the learning for key of the controller board, then the indicator light will be on. Wait for 6S when the indicator light goes out, then let go and press the learning for key, which indicates the successful of the clear mode.\n\nNote:\nNo retail package.\nTransition: 1cm=10mm=0.39inch\nPlease allow 0-1cm error due to manual measurement. pls make sure you do not mind before you bid.\nDue to the difference between different monitors, the picture may not reflect the actual color of the item. Thank you!\n\nPackage Includes:\n1 x Remote Control\n1 x Receiver\n1 x Antenna"]