["Stainless Steel Hexagonal Wet Film Comb Paint Wet Film Thickness Gauge Comb Regulation Wet Film Card 25-3000um\n\nFeatures:\nbrand new and high quality.\n- Stainless steel has high hardness, good wear resistance and is not easy to rust, not easy to wear and has a long service life.\n- The laser scale is deeper and the reading is easier.\n- Leather cover for easy carrying and storage.\n- Immediately after the various coatings are applied, the wet film thickness gauge is placed vertically and vertically. The thickness of the coating can be measured immediately on the surface of the flat workpiece coating.\n- Uses - Tools for coating thickness of coatings on new coated surfaces, such as wet paint film thickness, chemical, adhesive, architectural coatings, measuring paints, varnishes, etc.\n\nSpecifications:\nColor: silver\nMaterial: stainless steel\nSize: 65×37mm/2.56\"×1.46\"\nMeasuring range: 25-3000um\nPacking: leather cover\n\nInstructions:\n- After the application, the wet film thickness gauge was placed vertically on the smooth surface of the wet film coating, the wet film thickness gauge was removed from the wet film, and the wet film thickness was measured.\n- The wet film thickness should be between the shortest tooth and the adjacent one, not the wet film.\n- Two measurements were taken at different locations using the same method to obtain a range of representative results.\n- After use, clean the wet film thickness gauge.\n\nNote:\nTransition: 1cm=10mm=0.39inch\nPlease allow 0-1cm error due to manual measurement. pls make sure you do not mind before you bid.\nDue to the difference between different monitors, the picture may not reflect the actual color of the item. Thank you!\n\nPackage Includes:\n1 × Hexagonal Wet Film Comb"]