new and high quality OOTDTY Features: The product has a total of four buttons, button , button minus, SET (setting button), reset button. There are two sets of digital tubes showing the actual temperature and the set temperature respectively. All parameters are automatically remembered after 5 seconds of setting. Operation use: Red digital tube: actual temperature Blue digital tube: set temperature Button : Increase the set temperature Button minus: Decrease the setting temperature factory settings: Press and hold the button button for more than 5s at the same for time, the system will settings data. Set button (SET): Short press SET, set the temperature to add 50 C each for time, the user can quickly press SET to quickly set to the vicinity of the preset temperature value, and then fine-tune to the preset temperature by pressing the button. 2. Press and hold SET to enter the parameter setting . There are several parameters of P00~P05 for the user to set. After entering the parameter , press SET shortly to P00~P05. Under the corresponding parameters, the corresponding data is added or subtracted by pressing the button, and the automatic memory data is returned to the display after the system is completed for 1. seconds. Code Cable: P00: heating C cooling P01: Temperature difference backlash (0~500) P02: Temperature correction(-10~10) P03: Maximum temperature alarm value (500) P04: Minimum temperature alarm value (-60) P05: Data lock (ON/OFF) Specification: : DC12V Output: 10A Temperature control : -60~500 Temperature accuracy: 1 Resolution: 0.1 rate: 0.5S for shell material: ABS Dimensions: 79x43x26mm/3.11x1.69x1.02inch Installation size: 74x39mm/2.91x1.54inch Cable length: 42cm Color: Black Quantity: 1 Set Note: 1.Please allow 0-2mm error due to manual measurement. pls make sure you do not mind before you bid. 2.Due to the difference between different monitors, the picture may not reflect the actual color of the item. Thank you! Package Includes: 1 x Digital Temperature Controller 1 x K-type Thermocouple _x000D_