Installation:1.To install the cooling fan,press the fan tabs over the VXL-3S heat sink until they snap on.2.Plug the VXL-3S cooling fan connector into the plug on the front of the cooling fan.Notes:1.The fan must blow air down the flns.Be the "V" decal up.2.The fan plug should face the front of the VXL-3S3.The fan is not water resistant.4.Always turn off the VXL-3S and unplug the model battery when not in use5.Periodically removethe fan and clean and debris from the fan and the heat sinkSuit For:for Hoss VXLfor 4-Tec 2.0 VXL AWD Chassisfor Bandit VXLfor Drag Slashfor Fiesta ST for VXLfor VXLfor Slash for Slash Ultimatefor Slash VXLfor Slash for Slash VXLfor Stampede VXLfor Stampede VXLColour:blueMaterial:plasticPackage Contents:2 x RC Car Cooling FanOnly the above package content, other products are not included.Note: Light reflection and different displays may cause the color of the item in the a little different from the real thing. The measurement allowed error is +/- 1-3cm. Note: Due to the light and screen setting difference, the item's color may be slightly different from the pictures. Please allow slight dimension difference due to different manual measurement. Sold by-YJL official store