assurance tested, more responsive, less expensive, easier to install. line pressure barbed push lock T-fitting adapter. Tee off the line for reliable pressure readings directly from . Keeping track of your pressure performance is vital for your engine. Hose clips secure to the fitting for better arrangement. Application:For Universal Fitment. (Cars, Motorcycles, Trucks, Vehicles, Boats and etc.) High temperature plastic rings are installed at both ends of the mount for sealing Installation Steps: 1. Cut the Line: Using a tube cutter, remove approximately one inch from your line and secure both ends of the cut line with the included hose clamps. 2. Install the Adapter: Install the T-fitting into the two cut ends by firmly pressing the hose until fully sealed. Secure the T-fitting to the line using the hose clamps. 3. Thread in the Sensor: Thread your pressure sensor into the port on the T-fitting adapter and tighten. Your sensor is now in place and ready for use. Note:Installation guide not included, Please check as much as possible to make sure the item is what you need. Tips:The product may be updated constantly ,Due To Different Batches, The Actual Product May Have Slight Differences Or Color Differences, Which Does Not Affect Use Note:due to different production batches, the colors of accessories are random, and the designation is not accepted. Color:As Shown Material:stainless steel Package Contents: 1 x Pressure T-Fitting Adapter 2 x Hose Clamp 2 x Plastic Ring Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.