4.3inch LCD Touch Display for , 800x480 resolution, IPS screen wide angle Supports Pi 4B/3B+/3A+/3B/2B/B+/A+, CM3/3+/4(CM3/3+/4 requires extra adapter board) Supports Raspbian, 5-points touch, driver free Supports / Kali / WIN10 IoT, single point touch, driver free Supports Retropie, driver free 1. Capacitive , support up to 5-point touch 2. interface, refresh rate up to 60Hz 3. Tempered glass capacitive , hardness up to 6H 4. When used with , supports OS / / Kali and Retropie, driver free. 5. Supports software control of backlight brightness Hardware connection Connect the interface of 4.3inch LCD to the interface of . For easy use, you can fix the on the backside of the 4.3inch LCD by screws Software setting Supports OS / / Kali and Retropie for . 1) Download from the website. 2) Download the compressed file to the PC, and unzip it to the . file. 3) Connect the TF card to the PC, use SDFormatter software to the TF card. 4) Open the Win32DiskImager software, select the system downloaded in , and click 'Write' to write the system . 5) After the has finished writing, save, and quit the TF card safely. 6) Power on the and wait for a few seconds until the LCD displays normally. And the touch function can also work after the system starts. color:Blue+black Material:PCB Package Contents: 1 x 4.3inch LCD 1 x FPC 15PIN 1.0 pitch 50mm (opposite sides) 1 x Screws pack Only the above package content, other products are not included. Note: Light and different displays may cause the color of the item in the a little different from the real thing. The measurement allowed error is +/- 1-3cm.