Feature:1. Single channel USB to serial / parallel ports with a variety of configurations.2. Whole USB protocol handled on the chip, no USB specific firmware programming required.3. USB 2.0 high-speed (480Mbits/Second) and full speed (12Mbits/Second) compatible.4. Multi-protocol synchronous serial engine (MPSSE) to simplify synchronous serial protocol (USB to JTAG, I2C, SPI (MASTER) or bit-bang) design.5. UART data transfer rate up to 12Mbaud (RS232 data rate is limited by external level shifter).6. USB to synchronous 245 parallel FIFO mode transfer up to 40 megabytes/second.7. USB to asynchronous 245 fifo mode data transfer rate up to 8 megabytes per second.8. Support for special half-duplex FT1248 interface with configurable width, bidirectional data bus (1, 2, 4 or 8 bit wide).9. CPU - style FIFO interface mode simplifies CPU interface design.10. Fast serial interface option.11. FTDIs royalty-free Virtual Com Port (VCP) and Direct (D2XX) drivers eliminate the requirement for USB driver development in most cases.12. Adjustable receive buffer timeout.Specification:Condition: 100% Brand NewItem Type: USB to JTAG UART/FIFO SPI/I2C ModuleTypical ApplicationsSingle chip USB to UART (RS232, RS422 or RS485)USB to FIFOUSB to FT1248USB to JTAGUSB to SPIUSB to I2CUSB to Bit-BangUSB to Fast Serial InterfaceUSB to CPU target interface (as memory)Package List:1 x Module3 x Pin Header