Applicable table for car models Introduction: 1. General Motors Vehicle Sensors Tire Pressure Release Tool: Suitable for General Motors vehicles equipped with 315/433 MHZ Vehicle Sensors Tire Pressure monitoring system s (Chevrolet/Buick/General Motors/Opel/Cadillac, etc., 2006-2019, sedans, SUVs, pickup trucks). Only designated diagnostic tools can be used to readVehicle Sensors Tire Pressure s on 2012 and later models. 2. Easy to use, this EL-50448 OEC-T5 is simple, fast, and easy to use, with just 3 steps to help you easily reprogram all Vehicle Sensors Tire Pressures. Pressing a button can activate each Vehicle Sensors Tire Pressure monitoring system within 1-2 minutes. 3. How to use it? Ensure that your car is in Vehicle Sensors Tire Pressure monitoring system learning mode and place the tool tightly against the tire sidewall, close to the valve stem. Fix the tool on the tire sidewall while pressing the learn button until the horn sounds once. 4. Essential trial tools: EL-50448 OEC-T5 is a necessary tool for replacing Vehicle Sensors Tire Pressure s, dismantling Vehicle Sensors Tire Pressure alarms, or replacing tires. Very suitable for monitoring Vehicle Sensors Tire Pressure, training your cars s so that the Vehicle Sensors Tire Pressure monitoring system warning light does not light up. Kind Reminder 1. Please review the list of available supported vehicles, this tool is not applicable to trucks. 2. When using EL-50448, please confirm if the antenna position is correct. 3. The battery is not included in the packaging. Please remove the 9V battery when not in use. 4. Install/reinstall the battery according to the + and - symbols marked on the product. When do you need this tire relearning tool? 1. A new Vehicle Sensors Tire Pressure monitoring system has been installed, and the removal or addition of air to the tire cannot make the system recognize the new . 2. There is no quick and easy way for the ECU to relearn new tire information when doing tire rotation. 3. When the Vehicle Sensors Tire Pressure indicator light is on, after maintenance, it is necessary to reset the Vehicle Sensors Tire Pressure to turn off thelight. 4. After resolving issues such as low Vehicle Sensors Tire Pressure or leakage/replacement or installation of Vehicle Sensors Tire Pressure monitoring equipment/tire replacement, damage, etc., it is necessary to reset the. 5. Replace winter or summer tires. How can I set my car to Vehicle Sensors Tire Pressure monitoring system learning mode? 1. Place the gear in the P position. 2. Use cruise control to selectrelearn mode in the instrument panel settings. 3. If the horn sounds once and the Vehicle Sensors Tire Pressure monitoring system indicator light flashes, the learning mode has been successfully entered. If equipped, the message center will display the Left Front (LF) tire. How to use EL50448? 1. Set the vehicle to the Vehicle Sensors Tire Pressure monitoring system learning mode. (The car whistles twice) 2. Start the relearning process from the left front tire and point the antenna to the correct position. Press and release the power button. After the speaker chirps, switch to the next tire. 3. Rest thes in this order: left front, right front, right rear, and left rear. After all s are reset, the car horn sounds twice, indicating that the Vehicle Sensors Tire Pressure monitoring system has completed relearning.