This is a simple filament cutter for the awesome for ERCF so tip tuning is less important. The cutter get's mouted to the selector chart just behind the encoder - the cutter is basically an arm that swings to the left and right. Since the for ECAS sits now on the Arm the filament path can be opened by swining the arm to the side. Then the ERCF can feed some filament mid air (the filament tip) and when the arm swings back to close the filament path the tip gets cut off by on the arm. The cut off tip just falls off to the ground and the filament can be loaded with a clean tip time. Color: As Shown Material: Plastic+Metal Package Contents: 1 x Consumables cutter kit Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.