R12DSM 2.4G 12Channels Mini RC Receiver SBUS/PPM RX For AT9 AT9S AT10 AT10II Transmitter FPV Racing Drone Features: R12DSM 2.4G twelve-channel receiver with DSSS and FHSS dual spread spectrum anti-jamming technology,For Rady remote control AT10II/AT10/AT9S Pro/AT9S/AT9 Signal output type Can output 12 channels of SBUS or PPM signal. Receiver indicator is blue,output 12 channels of SBUS signal. Receiver indicator is red,output 12 channels of PPM signal. Signal switching Short press the(ID SET)switch on the side of the receiver twice(within one second)to complete the switching of SBUS and PPM signals of the R12DSM. Specification: 1.Number of channels: 12 channels(adaptive 10,12 channels: that is,if the remote control sets 10 channels,the R12DSM outputs 10 channels of SBUS or PPM signal,if the remote control sets 12 channels,the R12DSM outputs 12 channels of SBUS or PPM signal) 2.Working voltage:4.8-6V 3.Operating current:40-180mA(input voltage 5V) 4.Size:30*15 MM 5.Weight:2.5g 6.Resolution:4096,0.5us per stage with high accuracy,so that all the servos are as still as water 7.Distance:1100 meters on the ground, about 4000 meters in the air,the actual control distance and flight environment Pair code Each transmitter has an independent ID code. Before starting to use the equipment, the receiver must be matched with the transmitter. Once the pairing is complete,the ID code is stored in the receiver and does not need to be matched again. When you purchase a new R12DSM receiver, you must re-pair the code, otherwise the receiver will not work properly. 1.Place the transmitter and receiver close to each other. 2.Turn on the transmitter power switch and power up the receiver. 3.Press the code key of the receiver for more than 1 second,the red light will start flashing,indicating the start of the code. 4.When the red indicator of the receiver stops blinking and becomes light,it means the code pairing is completed. If the code pairing is not successful, the signal display will not appear on the main interface of the remote control display,and the red indicator of the receiver will flash slowly. Receiver Antenna Installation To ensure the signal transmission effect of the receiver,please pay attention to the following points. 1.Make sure the antenna is as straight as possible,otherwise it will reduce the effective control range. 2.Two antennas please keep 90 degrees angle 3.Large model machines may have metal parts that affect the signal transmission,in this case,the antennas should be on both sides of the model. In this way,you can keep the best signal status in any flight attitude. Package includes: 1*R12DSM Receiver Note: After the connection procedure is completed,turn the transmitter off and on again for the procedure to take effect to confirm that the receiver is indeed properly connected to and controlled by the transmitter. Do not perform the connection procedure when the motor power wire is connected to the governor or when the engine is operating,as this operation may result in serious injury.