Features: 1.Uses the world's most advanced fingerprint algorithm to ensure the high accuracy and optimal speed of fingerprint recognition which makes the recognition time is less than 1 second. 2.TCP/IP communication, simple and practical network connection, push technology supporting, access control network and data collection work can be shared freely. 3.The infrared optical fingerprint collector can prevent strong light, dry fingerprints, shallow fingerprints, and can work offline. And it supports Wiegand26 signal and can be used with any controller on the market. 4.Supports self?service download of EXCEL attendance reports by USB flash drive, supports unlocking, exit switch andf multiple verification methods, also supports anti?tampering, anti?reverse. 5.There are three verification methods: fingerprint, password, ID card. And it has T9 touch buttons, 2.4?inch display, simple and clear screen. Specification: Item Type: Access Control Attendance Machine Material: ABS Plastic Fingerprint Capacity: 1000 Card Capacity: 1000 Password Capacity: 1000 Record: 160000 Communication Method: TCP/IP, USB Lcd Monitor: 2.4 inches Language: English Sensor: Light Sensor Button: T9 Touch Button Power Supply: 12V 2A Working Temperature: 0-45 Working Humidity: 20-80 Identity Verification: Fingerprint/Password/ID Card Usb Disk: Support Card: 125khz ID Card Anti-Reverse: Support Wiegand Signal Output: Wiegand26 Output Product Size: Approx. 194 x 79 x 34mm/7.6 x 3.1 x 1.3in Suggested Using Steps: Step 1: Install the device and power on the device. Step 2: User registration, fingerprint ID registration, password and privileges set. Step 3: Verify user identity and confirm whether the registered fingerprint, ID and password are available. Step 4: Insert the USB flash disk, enter the "shift setting" of the main menu, download the shift, then pull out the USB flash disk and insert it into the computer, open the attendance setting table, and set the shift and personnel. Step 5: Insert the USB flash disk into the attendance machine, enter the "shift setting" of the main menu, and upload the attendance setting table. Step 6: Check whether the equipment time is accurate. After the confirmation is completed, you can start attendance. Step 7: At the end of the month, enter the main menu "download report" of the attendance machine, and download the standard report through the USB flash disk, and then go to the computer statistics. The User Interface of the Device is Shown in the Figure: Attendance Status: Close to the front of the device, display the scanning status on the screen, and the information will be displayed after fingerprint recognition, ID recognition, employee identification or password. Date and Time: Display the current device time. The date and time can be calibrated in the elapsed time in the advanced settings menu. Press the menu button in the user interface, fingerprint recognition, ID card recognition or password recognition administrator enters the main menu interface. PackageList: 1 x Access Control Attendance Machine 1 x USB Data Cable 1 x Hanging Board 1 x CD 2 x ID Card 3 x Connecting Cable 1 x Network Cable 1 x Installation Screw Package 1 x Instruction Note: Please note that the new type and old type of this product will be sent randomly, and make sure you will not mind before ordering.