Description: 【Two Way Conversion】 :The 3.5in IDE to SATA adapter card can be converted in both directions, so that your old IDE hard drive can be connected to a SATA motherboard, or your old motherboard can be connected to a SATA hard disk. 【Easy to Install】: 3.5in IDE to SATA Riser Card, standard SERIAL ATA specification, supports large capacity storage devices (depending on the motherboard). It can be used with various machines and is easy to install. 【Features】: IDE Hard Disk Drive Adapter, support hot swap, plug and play; transfer rate up to 1.5GB/S. 【Applicability】: 3.5 inch IDE to SATA adapter card supports standard ATAPI, ATA/133, ATA/100, ATA/66, ATA/33.EIDE. 【Easy to Use】: The old IDE motherboard can be connected to the SATA hard disk, no driver is required, and the hard disk can be found directly in the host BIOS or DOS, WINDOWS. Specification: Material:PCB SATA hard disk cable length: 29CM Wire length: 20CM. There is a 40pin IDE port. Connect the IDE cable Has a SATA port There is a 4pin power port Convert Parallel ATA motherboard device to SATA interface Compatible with SATA 1.0 standard Size Chart: 5.5cmx4.5cmx1cm/2.17inchx0.39.77inchx1inch Package Includes: 1x 3.5in IDE to SATA Riser Card Note: Please allow slightly errors due to manual measurement and different monitors.