It works on the majority of inflatable stand up boards. It is also suitable for boats and kayaks which also use the Halkey-Roberts valve for inflation.Use your compressor or tire pump to easily reach 20 PSI.Be very careful not to over inflate your board or craft, and check the board's pressure frequently. This is an adaptor only. The speed at which your board inflates will depend on the pump used.Because the compressors/tire pumps take time to inflate, it is recommended to inflate the board by hand hand pump until it becomes difficult to pump, and then use the adaptor to top off the pressure. Remove your SUP valve cap and ensure that the valve is sealed for inflation by rotating the central pin into the outer/closed position.Insert the valve adapter into the SUP valve the same way as you would insert the pump hose nozzle. Connect any standard schrader pump to the valve adapter fitting to inflate your board. Monitor board pressure frequently while inflating If you have any problems, please contact with us directly. Simply e-mail us the problem, the solution will be provided in the least time.