Feature:1. Stable Working: Ensuring stable working performance under 0.1 to 1.0MPa pressure, the air cylinder has high efficiency.2. Double Action: Double action type together with single rod allows for loading on both directions, which is very reliable.3. Thickened Body: Thickened and finished body promises small stretching as well as smooth operation without getting stuck.4. Good Material: Having been through electroplating treatment, the aluminium alloy has high strength and not easy to deform.5. Easy to Install: G1/4 installation hole with M16 x 1.5 thread will adds more convenience to the installation.Specification:Item Type: Air CylinderProduct Material: Aluminium AlloyProduct Model: SC50-100-SCylinder Bore: Approx. 50mm / 1.97inCylinder Stroke: Approx. 100mm / 3.94inThread Size: M16 x 1.5Mounting Hole Thread: G1/4Pressure Range: 0.1-1.0MPaAction Mode: Double Action TypeWorking Medium: AirWorking Temperature: -20-80Rod Type: Single Rod.Package List:1 x Air CylinderNote:1. When the load changes during work, a cylinder with sufficient output power should be selected; 2. Under high temperature or corrosive conditions, the corresponding high temperature resistant or corrosion resistant cylinder should be selected; 3. In places with high humidity, a lot of dust, or water droplets, oil dust, welding slag, the cylinder should take necessary protective measures; 4. Before the cylinder connects to the pipeline, the internal impurities in the pipeline must be cleared to prevent debris from entering the cylinder; 5. The medium used in the cylinder should be filtered by a filter element above 40m before being used; 6. In a low temperature environment, measures preventing freezing should be taken to prevent the moisture in the system from freezing;7. Avoid side load, otherwise the piston will bend, deform and damage the thread at the end. The single acting type cannot be loaded on the return; 8. When the cylinder is removed and not used for a long time, pay attention to rust prevention on the surface, and dustproof clogging cover should be added to the intake and exhaust ports, and pay special attention to the front and rear covers not to be disassembled.