Feature: 1. WIRE REQUIREMENTS: End fed antennae needs to prepare about 2.5㎡ of wire, 8 sections of 40.4m/132.5ft, and trim to a frequency suitable for talent use 2. POWER RESISTANT: Professional end fed antennae, can withstand less than 150W single sideband, FT8, FM, AM, FSK less than 80W power, to meet your different needs 3. EASY TO USE AND PORTABLE: This end fed antennae is 1:49 balanced to unbalanced converter, standard interface, easy to install, fast and convenient. Small size, easy to carry 4. MULTI DIRECTIONAL: This antennae frame is set to straight tension and does not need to be too large to allow for a little sagging camber. Because is a multidirectional antennae, you only need to choose an open place without paying attention to its directionality. Non metal ropes must be used at both ends of the antennae, and metal ropes cannot be used, otherwise the parameters of the antennae will be affected 5. SETUP REQUIREMENTS: Within the entire length of the end fed antennae, it must be more than 3 meters away from obstacles(including walls, trees, leaves, and non metals). If you encounter metal objects(such as wires, window, railings), you must be more than 5 meters away to reach the proper state 6. HEIGHT SETTING: The higher the height of the end fed antennae frame, the better. Can be pulled horizontally, vertically, or diagonally. Which is recommended to check the rope every 6 times, once a month, in order to find problems in time to replace Specification: Item Type: End Fed Antennae Material: ABS SSB