1. High-Temperature Resistant: These motorcycle hand heated grips are made of high-temperature resistant nitrile rubber, providing durability and heat resistance. The right-hand grip is designed with a larger inner diameter to accommodate motorcycles with throttle cores, offering compatibility for various models. 2. -Wound Heating Wire: The heating wire is -wound, ensuring excellent comfort during use. With half the power consumption compared to similar products, these electric molded grips are truly efficient and energy-saving. Experience warmth without compromising performance. 3. Ultra-Thin Dedicated Heating Grip: Equipped with an ultra-thin dedicated heating grip switch, these scooter bar hand warmers offer easy control over the heating function. The switch is specifically designed for convenience and allows you to adjust the temperature according to your preference. 4. Silicone Resin Fiber Sheath: The throttle wire of the right adjustable hot grip handle is encased in a silicone resin fiber sheath, ensuring flexibility without affecting throttle operation. This design provides reliable and smooth handling while maintaining the integrity of the heating system. 5. Electronic Temperature Control: Featuring an advanced electronic temperature control system, these electric heating handles provide efficient power consumption. This system not only keeps your hands warm but also effectively protects the motorcycle's battery. Additionally, the grips come with high-quality switches that surpass the craftsmanship of old motorcycle hand grips. Item Type:Grips Model Name:Motorcycle Hand Heated Grips Input voltage:12V Handle Type:Sealable and pass-through electric handle Installation instructions: 1. Remove the old handlebar. 2. Wet the inside hole of the left handlebar with soapy water, and do not twist ittoo much when installing it. 3. When installing the balance iron on the left handlebar, adjust the position of the balance iron to slightly separate from the handlebar, and do not squeeze the handle when tightening the screws. 4. If the left handlebar slides on the steel pipe during use, remove the balancing iron and fix it with a few of 502 glue from of the handlebar. 5. Connect the red wire to the positive pole and the black wire to the negative pole (not reversed). 6. When installing the left handlebar, the power cable should leave enough margin for rotation. Colour:Black Material:Nitrile rubber Size:Handle length:left handle:125x35mm/4.92x1.38inch; right handle:127x35mm/5x1.38inch; Handle diameter:22mm Package Contents: 1set x Motorcycle Hand Heated Grips Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.