Features The product is a general smart receiver and it can be matched with the majority of the wireless receiver in the market, including fixed code 2262, 2260,2264,5326,M1E,M5E etc, learning code 1527, 2240, 6P20B, 6P20D etc. roling code HCS301,HCS300,HCS200,HCS201,HSC100,HCS1O1 etc and a part of customized remote controller. List of brands DEA DITEC PUJOL AVIDSEN ..... What can you do with it? For Garage Gate Door 1.The old motor is broken, connect the old motor as a receiver and receive the remote control signal 2. More people need to use it, connect an additional new receiver and add more remotes For Light Connect a light and control it remotely using the remote control Product Parameters 1.Power supply voltage: AC DC 7-32V / AC 85-250V / USB 5V 2.Frequency: 433.92MHz 433MHz 3.Code: Works with 433MHz fixed/learning/rolling code 4.Channel: 1 5.Operating temperature: -40C to +80C 6.Mode: Momentary, Toggle, Latched 7.Number of stored codes: 80 Guidance for Use I. Select mode 1. Three working modes:Momentary, Toggle, Latched Momentary: press and hold the button to open, release the button to close Toggle: press the button once to open, press the button again to close Latched: press the button once to open, press another button to close 2. Use the mode switch button to switch between modes The indicator light flashes once, the mode is Momentary The light flashes twice, the mode is Toggle The indicator light flashes three times,the mode is Latched II. Programming the remote control 1. Momentary mode Click on the mode switch button, the indicator light will flash once, then it is pointing mode Click the pairing button for 1 second, the blue light will be on, press the button of the remote control you need to pair for 1-2 seconds to complete the pairing. Other buttons are used in the same way 2. Toggle mode Click the mode switch button, the indicator light will flash twice, this is the Toggle mode Click the pairing button for 1 second, the blue indicator light will be on, press the button of the remote control you need to pair for 1-2 seconds to complete the pairing. Other buttons are used in the same way 3. Latched mode *Note: This mode requires one key to be programmed using either the Momentary or Toggle mode, and then another key to be programmed in the Latched mode. This pairing requires the use of a mode switch button for pairing. (For example, if your remote control has two buttons, use button 1 to program the button in either Momentary or Toggle mode, then use button 2 to program the button in Latched mode (1).Click on the mode switch button, the indicator light will flash three times and it will be in Latched mode (2).Click the mode switch button for 2 seconds, the blue indicator light will be on for a long time, press the button of the remote control you have not paired before for 1 second to complete the pairing. III. Clear code/reset (clear all remotes) Press and hold the pairing button for 3 seconds, the indicator light will flash twice, all remote controls will be cleared. Wiring method Remote Control for Receiver 12V 23A NO Battery Include Learning Code 433MHz