Instructions: 1. Place this protractor on your turntable platter with hole over spindle. 2. Move cartridge/ tonearm until stylus rests exactly on of . (120.9mm radius). Check cartridge is square with outer grid lines. - If not, loosen cartridge mounting screws and twist cartridge lightly until it is square. 3. Move cartridge/ tonearm until stylus rests exactly on of inner -eye (66.04mm radius), Rotate protractor around spindle as required. Check cartridge is square with inner grid lines.If not, change overhang, (move cartridge in or out along the axis) until cartridge is square. 4. Repeat and 3 till cartridge is square at both points. Tighten mounting Features: High cartridge alignment protractor provides improved visibility and eliminates tracking errors. Avoids the over- distortion to keep high sound Link to turntable setup guide with instructions included, printed directly on the protractor. Works with an S - arm and any 1/2inch mounted cartridge. Extra magnifier make you more clear when adjusting the overhang. colour: white Material: acrylic size: 19x4cm Package Contents: 1 x Overshoot Protractor Only the above package content, other are not included. Note: Light and different displays may cause the color of the item in the a little different from the real thing. The measurement allowed error is +/- 1-3cm.