Specifications Encoding Method:Fixed Code Hign-Concerned Chemical:None Origin:Mainland China Specifications: Product: Remote Control Color: Silver Black Dimensions: 5.5*3*1.5Cm Frequency: 433Mhz Working Voltage: Dc12v (27A Battery A Including) Operating Current: 8Ma Modulation Mode: Ask (Am) The Transmission Power: 100Mw Emission Distance: 50 To 100 M (Proof) The Encoding Type: Self Copy Uses: Garage Doors, Motorcycles, Car Alarm Products, Home Security Products, Short-Range Wireless Remote Control Products, Industrial Control Products Specifications: 1.Chips Could Be Copied: 2260 (All Manufacturers); 2262 (All Manufacturers); Pt2264,5326 (All Manufacturers); Sc5262, Ht600, Ht680, Ht6207, Ht6010, Ht6012, Ht6014, Smc918 Series, 527 (All Manufacturers); 1527 (All Manufacturers); 2240 (All Manufacturers); Hcs101, Hcs200\Hcs201 (Part Code), Hcs300\Hcs301 (Partial Code), Part Single Chip Microcomputer.......... 2.Code Cleaning Method: 1). When You Press A And B At The Same Time, The Led Indicator Will Be Steady For 1 Second And Then Blink 2). If The Code Clearing Is Successful, It Means That All Key Stored Data Has Been Cleared. If The Operation Is Not Completed, You Can Repeat The Above Operation To Clear It Once 3), After The Completion Of The Clear Code, Press Any Key Will Flash. Press The Key Without Data Is A Flash. Press The Key With Data Is A Led Indicator Light Is Steady On To Send Data Note: The Original Remote Control Can Not Perform Code Clearing Operation! 3. Copy Method One Hand Keeps The Original Remote Controller, While Another Keeps The Copy Remote Control, The Two Remote Controls Should Be Placed As Closely As Possible (The Ideal Situation Is To Put The Two Remote Controls On The Desktop Side By Side With Zero Distance), Respectively Press Down The Copy Button, When The Led Indicator Light Flashes Quickly After Three Flashes, This Copy Is Successful, Other Key Operating Methods Are The Same. Some Remote Control Has A Smaller Transmitting Power, So The Original Remote Control Should Be Placed Back To The Copy Remote Control To Be Operated. For The Presence Of Noise, It Should Avoid Interference To Operate, If The Copy Is Not Successful, It Should Recopy After Clearing Code.( Attention:Your Original Remote Control Must Be Able To Work And The Same As Our Remote Control Frequency) Notice: The Essential Condition For The Selection Of The Remote Control;The Copyed Remote Control Operates Normal,Chip Is Compatible And Frequency Is Correct. Before Buying,Please Make Sure The Copyed Remote Control Operating Frequency Or Choose & Buy The Frequency Adjustable Type Remote Control. Before Buying,Please Confirm Whether Your Remote Control Can Be Copyed Or Not. Our Remote Control Can Copy The Fixed Codes And Learning Codes Rather Than Stealth Cod