Description for BMW Mini One Cooper S Convertible R52 (2001-2006) rear hood soft top weather rubber seal repair self adhesive. Save money by replacing your old, cracked, worn-out weather seal with this DIY rubber repair kit designed for the back of the BMW Mini convertible. This product replaces the top rubber above the chrome trim that wraps around the rear above the boot and quarter panels, an area prone to aging and sun damage.The rubber is self-adhesive with 3M tape and measures approximately 2 meters in total length. Minor trimming is required to fit the length and around the third brake light.Installation Instructions: Step 1: Clean the surface thoroughly to ensure maximum adhesion. Step 2: Apply the new rubber strip over the flat edge where the old rubber was removed, overlapping slightly onto the roof material. Use additional adhesive to secure the bond. Ensure correct placement, as the adhesive sets quickly.The new rubber has a slightly increased profile where it overlaps the chrome, providing improved appearance and better protection against weather and UV damage. This repair has been tested through multiple UK seasons and proven durable.Avoid high-pressure washing of the roof area. Clean with a sponge and rinse with water. For added security, apply super glue (not included) in hidden areas to prevent lifting, or use a bead of silicone if needed.For easier installation, remove the strip before cutting to avoid damaging the roof fabric. Tamper-proof Torx screws under the chrome strip can be accessed by releasing the side latches (boot loading mode), allowing the lower roof section to be tipped up. Support with a suitable prop when open.Package includes: 1x replacement self-adhesive rubber seal