Features For Less Than 200kA Electrical Circuit: The arrester module(surge protector) is suitable for 50Hz(or 60HZ) impulse current capacity not greater than 200kA in the electrical circuit Absorb, Consume or Discharge Surge Current: Working for limiting transient overvoltage amplitude, absorb, consume or discharge surge current energy Convert to Lower Overvoltage Category: In the case of a higher overvoltage category, the electrical components to be protected can be converted from overvoltage category to lower overvoltage category Electrical Appliances Protection: Suitable for the protection of electrical appliances in households and similar places when there is an induced overvoltage in the line, and protection when operating overvoltage occurs TH35mm Wide Rail Installation: Installation method is matched with TH35mm wide rail, easy and convenient Specification: Item Type: Surge Protective Devices Product Model: BEM-LY80 Product Specifications: 4P80KA Rated Voltage: 220V/380V Maximum Sustainable Working Voltage: 385V Maximum Discharge Current: 80KA Nominal Discharge Current: 40KA Voltage Protection Level: ≤2.2KV Response Time: ≤25nS Ambient Temperature: -40℃~+80℃ Altitude: Not more than 2000meter Relative Humidity: Not more than 90%(25℃) Package List: 1 x Surge Protective Devices Note: 1. The indicator window of the module is green (normal). When the module deteriorates, the indicator window turns red and must be replaced in time.2. The surge protector can be equipped with (FS) remote remote signal alarm. The remote signal contact has one normally open and one normally closed. If one or more modules of the surge protector fail, the contact will be closed and a fault alarm signal will be sent. Indicates that the module is faulty and must be replaced.3. Frequently check the air switch or fuse on the serial line. Package List 1 x Surge Protective Devices