Filler kit for Seastar hydraulic steering - 2 piece bleed set with hos editionUsage Tips:Specification:<br> Material: Polyurethane, Stainless Steel<br> Color: Gold Tone, Black,Clear<br> Bridge Tube Inner Dia. :9mm/0.35 inch<br> Bridge Tube Length: 64cm/25.1 inch<br> Bridge Tube Outer Dia. : 10mm/0.39 inch<br> Filler Hose Thread Size: 1/4 NPT<br> Filler Hose Hole Dia. : 8mm/0.31 inch<br> Filler Hose Length: 66.7cm/26.2 inch<br> Filler Hose with Screw Cap Dia.: 26mm/1.02 inch<br> Filler Hose with Screw Cap Outer Dia. : 12mm/0.47 inch<br> <br> Fitment:<br> Fit for Seastar inboard, outboard hydraulic steering systems. Used for refilling your boat's steering system fluid.<br> <br> Basic Instructions:<br> 1. Attach bottle to helm reservoir (do not pierce bottle)(do not let bottle run empty).<br> 2. Connect bridge tube to fittings on steering cylinder and loosen fittings.<br> 3. Use helm to pump fluid through system by turning the wheel in one direction. Air bubbles will be pushed to the reservoir at the helm.<br> 4. Manually swing the outboard through full articulation to relieve trapped air.<br> 5. Note: Orientating fittings up while pumping fluid with helm will allow air to escape cylinder.<br> 6. Repeat 3-4 times necessary until no air is visible in bridge tube.<br> 7. Tighten fittings before removing bridge tube.<br> <br> Package Included:<br> 1 x Bridge Tube<br> 1 x Filler Hose with Screw Cap