Screen Vector Network Analyzer LCD 50KHz-1.5GHz USB 5V 200mA Antenna Analyzer Shortwave VHF UHF Measure Duplexer Filter

¥22,590
配送料無料

Screen Vector Network Analyzer LCD 50KHz-1.5GHz USB 5V 200mA Antenna Analyzer Shortwave VHF UHF Measure Duplexer Filter

  • ブランド: Unbranded

Screen Vector Network Analyzer LCD 50KHz-1.5GHz USB 5V 200mA Antenna Analyzer Shortwave VHF UHF Measure Duplexer Filter

  • ブランド: Unbranded
価格: ¥22,590
販売元:
¥22,590
配送料無料

在庫あり

以下の支払い方法を利用することができます

説明

["brand new and high quality\nFeatures:\n4-inch full-view LCD screen, with added for DC dimming, can be seen more clearly when used outdoors. Indoor use is more comfortable.\nThe bridge has been optimized to make full use of the harmonics of Si5351, and the 5th harmonic can now be used to measure up to 1.5GHz.\nWhen the fundamental wave is used, the CH0 output level is increased to 0dBm, and the reflection measurement is more accurate.\nThe previous abnormality of Nanovna-H near 6MHz was resolved.\nReproduce the design of the power management circuit, further reduces power supply noise, reduces USB power supply interference, reduces charging current, and protects the battery.\nOptimized PCB layout, accommodating 1950mAh battery, used for more than 8 hours.\nUART interface is reserved to facilitate DIY expansion.\nLightweight ABS housing provides good for protection for the device.\n\nSpecification:\nMeasurement Frequency: 50KHz~1.5GHz\nRF Output: 0dbm (±2dB, fundamental wave)\nFrequency Accuracy: <2ppm\nFrequency Stability: <0.5ppm\nMeasurement Range: 70dB (50kHz-300 MHz), 60dB (300M-900MHz), 40dB (0.9G-1.5GHz) enable expansion firmware)\n(Note: Please pay attention to the error caused by nonlinear transformation of the fundamental wave when using harmonic measurement.)\nPort SWR: <1.1\nDisplay: 4in TFT (320 x 480)\nUSB Interface: USB type-C Communication Mode: CDC (serial)\nPower Supply: USB 5V 200mA, Built-in 1950mAh battery, Maximum charging current 1A\nNumber of Calibration Points: 101 (fixed)\nNumber of Scanning Points: 101 (fixed)\nDisplay Tracking: 4, Marking: 4, Save Setting: 5\nMeasurement of S-parameters, voltage standing wave ratio, phase, delay, Smith chart, for time domain analysis, et\nMaterials: Metal+ABS\nPackage Size: app.24x14x3cm/9.45x5.51x1.18in\nColor: As pictures shown\nQuantity: 1set\n\nNote:\nPlease allow 0-1cm error due to manual measurement. pls make sure you do not mind before you bid.\nDue to the difference between different monitors, the picture may not reflect the actual color of the item. Thank you!\n\nPackage includes:\n1 x NanoVNA Main Unit(Including 4 inch for touch screen, 1950mAh battery)\n2 x 15cm SMA Male to Male RG316 RF Cables\n1 x SMA Female to Female Connector\n1 x SMA Simple Calibration Kit SHORT\n1 x SMA Simple Calibration Kit OPEN\n1 x SMA Simple Calibration Kit LOAD\n1 x USB Type-C Data Cable\n1 x Type-C to Type-C Cable(other accessories demo in the picture is not included.)"]
  • Fruugo ID: 369484712-800587472
  • EAN: 7927015236138

配送と返品

24時間以内に発送

  • STANDARD: 無料 - 間の配達 金 07 11月 2025–水 12 11月 2025 - 無料

中国より発送。

ご注文の商品は、お客様の仕様に従い、万全の状態で配送されるように最善を尽くしています。しかし、もし注文に抜けがあったり、注文したものと違う商品が届いたり、注文に満足できないその他の理由がある場合は、注文全体やその中のいずれかの商品を返品し、その全額の返金を受けることができます。 全額返金ポリシーを見る

製品コンプライアンスの詳細

以下に概説されているこの製品に固有のコンプライアンス情報を参照してください。

以下の情報は、この製品を販売する独立したサードパーティ小売業者によって提供されています。

製造業者:
次の情報は、Fruugoで販売される関連製品の製造業者の連絡先詳細です。

  • Shenzhen Yiyuxun Hardware Tools Co., Ltd.
  • Shenzhen Yiyuxun Hardware Tools Co., Ltd.
  • Room 205, Building D10, No. 5, Cengyao Industrial Zone, Yulv Community
  • Yutang Street, Guangming District
  • Shenzhen
  • China
  • 518000
  • cyjeniaunr@163.com

EUにおける責任者:
次の情報は、EUにおける責任者の連絡先情報の概要です。ここで言う責任者とはEUに拠点を置く指定経済事業者で、EU域内で販売される関連製品に関するコンプライアンス義務を負う者のことです。

  • Yating He
  • E-CrossStu GmbH
  • 69 Mainzer Landstrasse
  • Frankfurt am Main
  • Germany
  • 60329
  • E-crossstu@web.de
  • +4969332967674