1Using 32-bit digital signal processing control technology to achieve the best output performance of the motor 2Adopt digital-analog combination method and advanced power angle closed-loop control technology 3The current can be adjusted according to the load situation 4Large speed range, suitable for stepping motor, up to 3000rpm 5Optically isolated differential signal input with impulse response frequency up to 250KppsFeatures: 1. Using 32-bit digital signal processing control technology to achieve the best output performance of the motor 2. Adopt digital-analog combination method and advanced power angle closed-loop control technology 3. The current can be adjusted according to the load situation 4. Large speed range, suitable for stepping motor, up to 3000rpm 5. Optically isolated differential signal input with impulse response frequency up to 250Kpps 6. Adopt imported industrial grade components, the technology is mature and stable 7. Fault diagnosis stateindication and automatic protection function with undervoltage, overvoltage, overcurrent, short circuit, open circuitand tracking error tolerance 8. Suitable for all kinds of motion control automation equipment and instruments Specification: Condition: 100% Brand new Item Type: Stepper Motor Voltage: DC 24-50V Drive Current: 1.0-4.0A/phase, Automatic adjustment Subdivision: The highest resolution is 25600 steps / turn, 16 speedsare adjustable Maximum Pulse Frequency: 250Kpps Package List: 1 x Stepper Motor Note: 1. SW5 motor direction selection: OFF = CCWdirection rotation ON = CWdirection rotation SW6 function mode selection: OFF=(FOC) space vector control mode ON=(PM) jog motion mode 2. Do not reverse the power supply. Do not exceed the input voltage of DC50V. The green indicator light PWR lights when the drive is powered. 3. The driver has a single and dual pulse selection function, which can be set through the communication port. The factory default is pulse + direction. 4. When installing the motor, it is strictly forbidden to strike the motor shaft and the back cover to avoid damage to the encoder. Please connect the motor and encoder wiring correctly to the drive.