1. 2.13-Inch Capacitive Touch Ink Screen, 250x 122 Resolution 2. Supports 5-Point Touch And Custom Gesture 3. No Backlight Is Required, And The Display Content Of The Last Screen Can Be Maintained For A Long Time When The Power Is Turned Off. 4. The Power Consumption Is Very Low, Basically Only Consuming Power When Refreshing. 5. Based On Raspberry Pi40pin Gpio Interface Design, Suitable For Zero / Zero W And Other Two Main Control Boards 1. Working Voltage: 3.3V 2. Communication Interface: 3-Wire Spi, 4-Wire Spi 3. Partial Refresh: 0.3s 4. Overall Dimensions: Approximately 69.15 x 38.90mm 5. Display Size: About 48.55x23.70mm 6. Global Refresh: 2s 7. Refresh Power Consumption: 26.4mw(Typ.) 8. Point Pitch: 0.194x0.194mm 9. Sleep Current: Less than 0.01ua (Near 0) 10. Resolution:250*122pixels 11. Viewing Angle: 170 12. Touch Points: 5 13.Colour:As Shown 14.Material:ABS Note: Different Batches May Have Differences In Product Appearance, Color, And Printed Characters, Which Will Not Affect The Use Package Contents: 1 x 2.13-Inch Touch Electronic Screen 1 x Upper And Lower Shell 1 x Screwdriver 1 x Thermal Conductive Silicone Sheet 4 x Anti-Slip Rubber Particles 2 x Flat Head Screws Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.