The solar module stand is suitable for all solar modules of all sizes. Due to the fact that there is no need for large mounting rails for attaching the stands to the solar modules, the stands can be attached to all known solar modules with aluminum frames. To fasten the stands, use the included screws and nuts, with which you can easily and safely screw the stands to the already existing mounting holes with the solar module. Material: aluminium alloy AL6005-T5 Another great advantage of the solar module stands are the four individual fastenings, two of which can be adjusted in length. This gives you the possibility to flexibly position the solar modules and also adjust them in the angle of attack. This allows you to adjust the angle to the sun perfectly and individually in every season. The stands are best suited for mounting solar modules on facades or flat roofs. However, these can also be mounted on any solid surface. The set consists of two stands incl. required mounting material. Parameters: Length of guide rail adjustable: 36cm; Telescopic inner tube of the guide rail: 40-70cm; wall thickness: approx 2mm; Adjustable inclination angle: 15-30 degrees; Wall thickness of angle aluminium: about 3mm; Wall thickness of the edge press block: about 3mm; Load capacity: approx. 100KG Scope of delivery for a PV module 2 x aluminium telescopic rods 2 x Vario Console 4 x Rubber pads 1 x Screw Set Warm tips: If you have any questions about using the solarpanel brackets, please feel free to contact us. We will solve your questions as soon as possible.