Nano Tape Bubbles: This is the Nano Tape Bubbles you've been looking for The newly upgraded nano glue blister is not easy to break, has higher elasticity and buildability, and meets your various DIY ideas.Fun Toys: This nano tape bubble set can help you focus and relieve stress. You can use it to make a super cute bubble, perfect for playing with boys, girls, friends, classmates, colleagues and family. easy to useChoose a suitable length of nanoribbon, 2. Put a straw, 3. Add your favorite filler (glitter powder, glitter powder, etc.), 4. Seal the edge, 5. Tear off the protective film 6. Heat the dryer with hair One minute. 7. Then you can blow bubbles.DIY Nano Tape Bubbles: Because of nano tape, the bubbles are more durable and more elastic, allowing you to be more creative. You can make your favorite nano tape crafts any way you like, and even fill bubbles with water or quicksand.Packing list: Rectangular water polo bubble 45mmX90mm (with straw + glitter, sequins + 6 packs)2. The nano-tape around the straw is not tightened, and the edge of the nano-tape pocket is not tightened, resulting in air leakage.The fix: pinch the edges of the nanoribbon pockets before blowing bubbles. When blowing out bubbles, pinch the nanoribbon around the strawnanobelt. 3. The nano tape sticks together without gaps between them.Solution: Be careful not to let the central nanoribbons stick together and form pocket-like nanoribbons.4. The straw is blocked by nano tape.Solution: Note that the straw is 0.3-0.5 inches inside the nano tape and not blocked by the nano tape.The cause of the air leak?1. The nano tape is not tightened around the edge of the nano tape or around the straw.Solution: Squeeze the edges of the nanoribbon pocket well before blowing bubbles. After blowing the nanobubbles, pinch where the nanoribbons are attachedstraw. 2. The edge of the nanoribbon is too narrow.Solution: Leave at least 0.2 inches of nanoribbon edge.3. The size of the nanoribbon you cut is too small, and the bubbles are too large.Solution: Do not blow a single layer of nano tape longer than 5 inches.4. Insufficient heating time or uneven heating, resulting in local damage and air leakageSolution: Please use a hair dryer to evenly heat the nanobelt for more than 1 minute before blowing