["Description:\r\n brand new & high quality.\r\nFeatures:\r\nPrecisely monitor them from over-voltage sensing, overvoltage and electrostatic discharge Damage caused.\r\nTake place through the special treatment to avoid signal interference single network SPD\r\nMulit-level for protection, flow capacity, low clampling voltage, fast response for time, low insertion loss, transmission rate advantages.\r\nSpecial maintenance is not needed for the for protection device; please replace immediately in for case of damage by high voltage or for Thunder.\r\nProtectors have input (IN), output(OUT) mark, output terminal and protected, donnot connect the device to connect. Otherwise it will cause the protector the damage. \r\nEasy to install. Install between Ethernet and the protected device first, \"IN\" end is for input and \"OUT\" end is for output to the protected device, then set ground wire well and straight.\r\nOnly support network RJ45 monitoring device camera.\r\n\r\nSpecifications:\r\nMaterial:Aluminium Alloy\r\nColor:As the pictures Show\r\nPower:0~220V\r\nIsn=5KA\r\nImax=10KA\r\nQuantity: 1Pc \r\nNote: \r\n1.Transition: 1cm=10mm=0.39inch\r\n2.Please allow 0-1cm error due to manual measurement. pls make sure you do not mind before you bid.\r\n3.Due to the difference between different monitors, the picture may not reflect the actual color of the item. Thank you!\r\n4.No retail package\r\n\r\nPackage includes: \r\n1Pc x Surge Protector\r\n(other accessories demo in the picture are not included)"]