1. Keep the back clean before ironing, and adjust the temperature to suit the clothes according to the usage of the iron. 2. Put the cloth in the right place (don't tear off the glue) and iron it back and forth for a few times, usually about 10 seconds. 3. In order to prevent scalding, you can put a thin cotton cloth on the cloth sticker (it must be cotton, not faded cloth). After ironing, check the see if it is well ironed, and iron the edge a few times more. 4. It depends on the thickness of the decal to determine the temperature. If it is thicker, the temperature must be higher and the ironing time be longer. For cloth stickers, you can iron them on the back a few times. 5. Special attention: For cloth stickers with sequins or bright surfaces (because sequins are all plastic products), you must pad a layer of cloth and iron it at low temperature (below 130), or directly use a steam iron. Or put a wet cloth on it. In order to avoid the plastic sheet from melting due to excessive temperature. 6. The is to sew a few stitches of the patch with needle and thread after ironing, which is more firm and very docile. 7. If you don't have an iron , you can sew the patch on the clothes directly with the same color thread. Colour:As Shown Material:Twill Package Contents: 13 x Halloween embroidery cloth stickers Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.