Specifications: The controller adopts single-chip controlled by microcomputer, the output pulse is accurate, and the welding quality is guaranteed. With the LCD display screen, the controller can display the welding parameters. The soldering iron and the input line are connected by U-shaped cold-pressed clamps, which is convenient to disassemble and . The controller adopts automatic welding mode, keeping manual trigger interface, can be selected according to your own use. Using 2 ounces of copper, the power strip increases the overcurrent capacity. Using five undisassembled MOS 300A lamps, they have good consistency. The MOS pipe driver adopts imported special driver chip, and the MOS pipe can be turned on as fast as 20ns, which can switch quickly to prevent the pipe from bursting. The MOS drive design increases the transient diode to protect the MOS and prevent the tube from exploding., The wire soldering iron and stainless steel wire entry use 10AWG multi-wire soft rope to increase the current capacitance. This controller is mainly for welding 0.1mm to 0.15mm nickel galvanized steel strip. Adding 25V10000uF high frequency low resistance capacitor to the power input, which is designed to compensate for energy and increase welding stability. Using Instructions:1: Power ConnectionThe controller is equipped with a 10AWG input cable with a length of 20cm, one end has been crimped with a U-shaped tip, and the other end has not been processed