FITMENT: For HONDA ADV350 ADV160 Be careful: 1. Prepare a glass of water and detergentmixed liquid, and feel the slippery feelof the mixed liquid with your hands is more suitable. 2. Clean the speedometer screen of the motorcycle with alcohol cotton (first wipe the speedometer screen with a moist cleaning cloth included in the package, then wipe the speedometer screen with a clean dry wipe, and finally wipe the speedometer screen with a dust removal sticker. Clean the speedometer screen without leaving any dust and foreign objects) (Remember: Never wipe the speedometer screen with ordinary paper towels and towels, because this will make your speedometer screen stick more and more dust. This will Makes the speedometer screen protector create a lot of bubbles) 3. Spray some mixed liquid of water and detergentevenly on the speedometer screen. Then stick the Speedometer Screen Protectordirectly on the speedometer screen. After pasting, use your fingers to gently adjust the position of the instrument filmto align it with the screen of your motorcycle speedometer (remember: be sure to adjust gently, not use too much force). 4. Use the gift cardto drive out all the water and air between the instrument membrane and the speedometer screen. When driving the water and airout, you can use a paper towel to absorb the water that is driven out at the edge. (Patience is a must when affixing a curvedor convexspeedometer screen) 5. After the protective film is attached and the bubblesare removed, wait for a few minutes quietly. When the protective filmhas a certain adhesion, you can put the thin filmon the other side of the protective filmCarefully tear off gently. 6. After completing all the steps, the speedometer screen cannot be washed and wet within 3 days. Features: 1.Protects cluster screen from scratches, dust, debris, heat and UV 2.Seals existing scratches underneath and makes the cluster screen like new again 3.Easy to clean and wipe the dirt off without the fear to scratch the cluster screen 4.Leave no residue when removed 5.Comes with Cleaning kit and Squeegee Description: Condition:100% New Quantity: 2 SETS In One Package Colour: As Shown Material: Thermoplastic polyurethanes(TPU) Package Inlcuded: 2 set in one package (with Cleaning kit and Squeegee) Installation: 1. Use the fiber cloth (clean and wet cloth) in the package to remove the dust and dirt on the speedometer screen 2. Spray an appropriate amount of water on the speedometer screen (it is best to use the mixed water of detergent and water, so that the position of the protective film can be well adjusted ). 3. Tear off the No. 1 surface film on the protective film, and then carefully stick the protective film on the motorcycle speedometer screen,After adjusting the position of the protective film, squeeze out the excess water and air with a hard card (small white card in the package). 4.after squeeze out the excess water and air,Wipe the moisture off the edge of the speedometer,Finally, tear off the No. 2 surface film on the protective film and complete the installation. (Note: please do not clear the speedometer screen within 3 days) (Due to personal craft problems, maybe a little bit bubbles is a normal phenomenon.) Note: