Product Description: Product Name Imitation carbon fiber fuel tank universal fishbone patch Product Material PET Drip Glue [Applicable models] Universal various Japanese street cars [Product color] Snake skin plaid pattern [Product size] Approximately 18 * 12CM [Product weight] Approximately 18G Product Introduction Locomotive fuel tank sticker, made of imitation carbon fiber drip glue Installation method: Dry sticking method: Tools: rags, sprinklers, scrapers, or credit cards 1. Clean the car body and keep it dry. 2. Determine the location that needs to be pasted. In general, slowly apply while scraping flat with a tool and removing the backing paper. 3. If the graphics are not very large, you can also peel off all the transparent transfer film and stickers before pasting. But be careful not to accidentally adhere. 4. After pasting, repeatedly scrape and press several times. Remove the transparent transfer film. 5. Make a cut with an art knife between the car door and the seam, and wrap it inward. 6. Do not let the car sticker and body have any separation or protrusions. Wet sticking method: Tools: rags, sprinklers, scrapers, or credit cards 1. Clean the car body and evenly sprinkle water on the parts of the car body that will be pasted - to reduce the viscosity of the sticker and facilitate adjustment of position. 2. Determine the location where the car sticker needs to be applied. Slowly apply while gently scraping flat with a tool and removing the backing paper. 3. When encountering door handles or anti friction strips, the materials should be cut open and wrapped according to the situation. 4. Adjust appropriately and ensure that the overall position of the figure is correct, then repeatedly scrape off water and bubbles with force. Remove the transparent transfer film. 5. Use an art knife to make a cut on the car door and seam, and wrap it inward. 6. Do not let the car sticker separate or protrude from the body of the car. 7. Try to let the moisture in the car sticker dry as much as possible, and if possible, heat and dry it moderately. According to the weather conditions, wash the car in one or two days. Kind reminder: Applying stickers to car paint may seem like an easy task, but sticking them straight and smooth is not that easy, especially when applying large patterns. If we tear off the entire back sticker and then stick it onto the car, it is easy to get fingerprints first. Secondly, the stickers may stick to each other and be difficult to control. Also, if the direction is wrong and we need to pull out the stickers and stick them again, it may be stretched out because the stickers are too soft. We should first lift a small part of the back sticker from the corner of the sticker (if necessary, this part can be cut off first); Then carefully align the position and stick the exposed sticker onto the car. Then we observe whether the position is correct. If there is no problem, we tear off a part of the back sticker and stick it again until it is fully attached. The principle of sticking stickers is to stick them from the inside out, that is, stick the middle part first, and then press outward with your fingers to push out the bubbles. If you stick it from the outside to the inside, the bubbles wont escape (for aesthetic reasons, you can use a small knife to cut through the bubbles). Another method is to apply soapy water to the car shell first, so that the sticker will not stick to the car shell and can be adjusted