_x000D_ _x000D_ SJ-10 level switch is driven by micro motor. The drive shaft is connected with the clutch. When the material is not touched, the motor runs normally. When the blade contacts the material, the motor stops turning. When the blade contacts the material, the output of the test mounting still has a contact point. At the same time, the power supply is cut off and the rotation is stopped. When the material falls, the resistance of the blade is moored. Testing and assembling depends on the torsion spring to restore yttrium to the initial state of strand. It can be adjusted according to the torsion magnitude of M material with different ratios. _x000D_ _x000D_ Product parameters: _x000D_ _x000D_ _x000D_ 1. Voltage with stand: AC 1500VX1MINUTE _x000D_ _x000D_ _x000D_ 2. Measuring Torque: 0.1N.M 0.03-0.01N.M _x000D_ _x000D_ _x000D_ 3. Applicable Proportion: 0.5G/CM3 _x000D_ _x000D_ _x000D_ 4. Connection mode: threads _x000D_ _x000D_ _x000D_ 5. Surface Material: Aluminum Alloy _x000D_ _x000D_ _x000D_ 6. Power supply: 220VAC 50Hz/24VAC _x000D_ _x000D_ _x000D_ 7. Power consumption: 4W _x000D_ _x000D_ _x000D_ 8. Contact Capacitance: SPTD5A/250VAC _x000D_ _x000D_ _x000D_ 9. Blade speed: 1R.P.M. _x000D_ _x000D_ _x000D_ 10.High temperature resistance 200 degrees _x000D_ _x000D_ _x000D_ _x000D_ _x000D_ _x000D_ _x000D_ _x000D_ _x000D_ _x000D_ _x000D_ _x000D_ _x000D_ _x000D_ _x000D_ _x000D_ _x000D_ _x000D_ _x000D_ _x000D_