Multi Function Digital Printer Sublimation Mug Heat Press Transfer Machine Features: 1. The pointer temperature display, automatic constant temperature, no need to place the shaping cup, directly heat up. 2. High temperature resistant thick silicone pad makes the hot pressing pressure more uniform, 400 degrees without deformation. 3. Automatic time control. 4. Pressure adjustment is convenient. 5. Full-size transfer of the entire cup can be achieved. 6. It can work continuously for 12 hours and has a beautiful structure. 7. Heat-resistant wire with a new aviation interface design. It is more resistant to heat and hard to burn. 8. Seamless welding, using top seamless welding technology, the weld is fine and smooth, and the quality is guaranteed. 9. Digital intelligent temperature control system has a longer life and is easier to operate. 10. Aviation interface, it is not easy to heat when used, and it is safe and secure. 11. Heat dissipation design, the rear part of the chassis adopts the built-in interface, and the fence type heat dissipation port dissipates heat and does not leak electricity.   Specification: Condition: Item Type: Mug Heat Press Machine Power: 300W Working Temperature: 0-220° Working Hours: 0-999Sec Main Use: Copy portrait photos/landscapes/anime characters on the cup.   Package List: 1 x Mug Heat Press Machine 1 x Pad 1 x Power Cable   Note: Please note that the new type and old type of this product will be sent randomly, and make sure you will not mind before ordering. Operation Process: 2. Adjust the left temperature control knob and turn it to the required temperature of 180 degrees. The heating time is about 1 minute. 3. Adjust the right timer knob to adjust to the appropriate time (15-30 seconds); 4. When the temperature reaches the set value, the machine will automatically enter the constant temperature state; 5. Place the porcelain cup with the picture in the cup machine (the size of the image page of the wrapped porcelain cup must be enough to cover most of the surface of the porcelain cup to prevent the surface of the porcelain cup from being scorched and to prevent indentation). Pressure handle, then the value on the thermometer will drop, so at this time let the cup machine heat up again (1-2 minutes), after reaching 180 degrees, press the green button on the left side, the time is up again. Music, then press the green button again, remove the porcelain cup (cool down to about 1 minute and then immerse in cold water to prevent the ink from spreading and scalding), dry it.   Product Adjustment: Pressure: adjust the ram on the pressure handle to increase or decrease the pressure; Time: Adjust the left timer knob to adjust to the appropriate time (0~30 seconds) Temperature: Adjust the right temperature control knob to the appropriate temperature (180 degrees)