SpyVerter R2 builds on top of the successful SpyVerter architecture and improves some of the key points of high performance HF reception. We designed the SpyVerter R2 to extend the coverage of the Airspy receiver series to the HF down to virtually DC with world class dynamic range, frequency stability . The architecture is still based on our switched double balanced mixer that moves the entire HF spectrum to the VHF band between 120 MHz and 180 MHz. We replaced the LO generator with a programmable, low phase noise PLL with 0.5 PPM VCTCXO. The Voltage control of this VCTCXO allows fine calibration of the operating frequency at the factory. The embedded microcontroller provides both the programming of the PLL (Si5351C) and the voltage control via its embedded . Once the is settled and the PLL is programmed, the microcontroller enters a deep sleep mode to any interference. We also added a 10MHz reference input clock for professional usages where phase coherency is required. When used with an Airspy receiver, the SpyVerter R2 can be powered from the integrated Bias-Tee, and only uses ~10mA of current (versus 47mA in the old design).An extra USB power supply input is provided for compatibility with receivers like RTL-SDR. Technical specifications RF Input 1kHz to 60 MHz IF Frequency 120 MHz - Positive Image Technology: Switched Double Balanced Mixer Conversion loss: 5.2 dB typ. 35 dBm IIP3 LO leakage: -42dBm typ. (12 dB lower than the SpyVerter) Phase noise at 10kHz separation: -122 dBc/Hz RF Filtering: Low Pass Filter with corner at 65 MHz - 75dB ultimate rejection IF Filtering: Band Pass Filter with corners at 120 MHz and 180 MHz - 75dB ultimate rejection Max RF power: 10 dBm Bias-tee voltage: 4.2v to 5.5v Current consumption: 10mA typ. Colour:Black Material:Plastic + Aluminum Alloy Package Contents: 1 x Software Defined Receiver Kit Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.