Feature:1. The outlet diameter is 1in(25mm) and the maximum lift is 8 meters, which can be used for batteries and solar panels2. Newly upgraded goodquality rotor with excellent copper wire, heat sink upgraded to 100 pieces, possess high temperature resistance, long life, sufficient power, longlasting work without burning the machine3. Using thickened stainless treatment, bring beautiful appearance, light weight, corrosion resistance, rust resistance, sturdiness and durability4. Ideal solution for remote watering needs without electricity, such as garden, farm irrigation and water tank filling5. Suitable for drainage of shipping, aquaculture, animal husbandry, industrial and mining enterprises; wonderful water pumps for all drainage of fresh water tanks, waterfalls, small ponds, and swimming pools, used with solar panels and battery systemsSpecification:Item Type: Submersible PumpPower: 180W(12V)/220W(24V)Body Material: Metal stretchBody Craft: Electroplating treatment, anti-rustMotor Material: CopperFilter Material: IronMaximum Lift: Approx. 8meter / 26.2ftMaximum Flow: 3000L/HMaximum Depth: Recommended maximum depth of approx. 6meter / 19.7ftCable Length: Approx. 2.5meter / 8.2ftMaximum Working Temperature: Within 40 degrees Celsius is recommendedConnecting Water Pipe Diameter: Approx. 2.5cm / 1inApplicable Scenarios: Suitable for various scenarios such as fresh water tanks, waterfalls, small ponds, swimming pools, yachts, and ship drainage.Package List:1 x Submersible Pump(without plug)1 x User ManualNote:1. The red wire is positive and the blue wire is negative. Before use, check whether the power supply voltage is consistent with the electric pump. The allowable error is 5%. The electric pump is connected to the generator and avoid over‑voltage. Disable household voltage.2. Do not use cables to lift the electric pump.3. The electric pump must not run without water. After the electric pump is used, it should be lifted up in a ventilated and dry place.4. If there are debris and other debris in the water source. The electric pump should be used in a setting with anti‑fouling debris to prevent the pump from being blocked.5. When the electric pump runs for 500 hours, the pump should be disassembled for maintenance, check the seals, clean the electric brush powder of the commutator, and replace the bearing grease and electric brush.6. It is best not to lengthen the electric pump cable. It is best to connect the cable directly to the battery. Please pay special attention to the positive (+) and negative (‑) poles. If the discharge head of the electric pump is too low, please replace the positive (+) and negative (‑) poles.