Item Type: Incubator ThermostatMaterial: PlasticWeight: Approx. 203g/7.2ozWorking Voltage: 220V 50HZPower: 4W1. Temperature Setting:In the normal display state of the meter, press the SET setting key to make the SV display in a flashing state, and find the number of digits required to set the temperature by pressing the shift key, and then set the required temperature through the increase and decrease keys. Finally, press the SET button again to turn the meter to the normal display state.2. Parameter Setting:This parameter is used to set alarms, PID constants and other parameters.In the normal display state of the meter, press and hold the SET key for three seconds, the parameter display symbols will be displayed on the PV display, and the corresponding value will be displayed on the SV display. Press the "SET" key in turn to display in turn And cyclically display parameter display symbols.3. Setting of technical parameters such as input type, temperature range, alarm mode, etc.In the normal display state of the meter, press the parameter setting to enter and find the data lock parameter LCK, set its codes to 1000, and then press the SET key to confirm the meter, press the SET key <key at the same time, about 3 seconds later, When COD=0000 is displayed on the PV display screen, press the SET key in turn to display and cyclically display the technical parameter display symbols.