The hot wire cutter for foam is equipped with 1 marker and 1 roll of hot wire of . 5 meter/ 5.47 yd long, allowing you to paint and on the surface of your foam board carving, and replace the hot wire for bow blade, bringing much . These hot wire styrofoam are practical for foam crafting and DIY, suitable for foam pumpkin carving, foam engraving, handmade practicing, foam modeling and so on, convenient for both beginners and skilled people to control. Notes: Not suitable for high density sponge, memory sponge and nylon fabric It is recommended that you heat the blade for a while using and take a rest after working for 30 minutes. After cooling, wipe the cutting needle with a wet sponge to avoid damage caused by excessive foam attachment and prolong the service life. Plug Type:US Plug,it applies to Canada, ,Mexico, Thailand, the , the Philippines,Taiwan and so on. : stainless steel+plastic+copper colour: green Package Contents: 1 x Temperature Controller 1 roll x heating wire 1 x cutting handle 1 x Bow Hot Blade 5 x Hot Blades 1 x Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the a little different from the real thing. The measurement allowed error is +/- 1-3cm.