About vinyl decals: These are die-cut decals mean it is without background. If there is a background color in the photo, it is only used as an example. The background color will be the color of the surface you place the sticker on, or clear if you place it on a window. The vinyl labels come in 3 pieces: 1. The top layer is a clear transfer tape. (It holds the decal or decal together until it is applied) 2. The middle layer is your actual decal or sticker (It is sandwiched between the application tape and the wax backing) 3. The bottom layer is the wax backing. (Protects the adhesive until the sticker is ready to apply) 4. Do not wash within 24 hours. Application instructions: 1. Wipe the sticker to ensure the transfer tape is properly adhered to the sticker.2. Clean and dry the desired area. Stickers stick best when cleaning smooth surfaces.3. Remove the wax backing slowly, making sure the sticker stays stuck to the clear transfer tape4. Carefully place the sticker in the desired area.5. Wipe the sticker from side to side, eliminating any air bubbles.6. Use an object such as a credit card to ensure that the entire sticker is fully adhered to the surface.7. Slowly remove the transfer tape, making sure no part of the sticker remains on the transfer tape.8. Check for air bubbles. In most cases, air bubbles can be worked into the edge of the sticker, but if not, the pin hole will allow air in and become virtually invisible. Your sticker is now hassle-free!