Product Introduction: Name: Aluminum Alloy Perforated Decorative Roof Frame Material: Aluminum Alloy + ABS Vehicle Type: Dedicated for Special Vehicles Color: Black, Silver Black Load Capacity: Not for load-bearing; decorative use only Specifications: - Aluminum Tube x2 - Wrap Angle x4 - Pad x4 - 3M Adhesive x4 - Adhesive Aid x1 Features: - No-drill installation using 3M double-sided adhesive and adhesive aid; no damage to vehicle body - High-quality aluminum profile made from durable aluminum material with sandblasted and oxidized surface treatment; resistant to rust and aging - Corner wraps made of high-quality ABS material; resistant to aging, low cold, and high temperatures Installation Steps: 1. Clean the roof surface thoroughly. 2. Identify the correct direction of the bracket and pole before installation. 3. Assemble the bracket and aluminum alloy main rod. 4. Position on the roof to confirm fitment and alignment. 5. Mark the position for accurate placement. 6. Apply adhesive aid to the bottom of the bracket. 7. Remove the yellow liner from the 3M adhesive and attach it to the bracket. 8. Apply adhesive aid to the roof installation area. 9. Remove the red liner from the 3M adhesive and install the bracket according to the marked position. 10. Secure the bracket with transparent tape for 2 days after installation. 11. Avoid car washing for 3 days post-installation; install only in dry, clear weather conditions. Important Notes: - This product is designed to be adhered to the inner side of the roof gutter. - Clean the installation area thoroughly, ensuring it is free of wax, oil, dust, and moisture. - In low temperatures (below 10°C), gently heat the adhesive primer with a heat source to enhance bonding. - Press firmly for 5 minutes after installation. - Keep dry and avoid car washing for 24 hours after installation. - Installation on rainy days is not recommended.