Car Dual Exhaust Tip 2.5 inch Inlet Bolt-on Square Slant Cut Stainless Steel Exhaust Tailpipe Muffler Tip UniversalFeature:1. Fixed by 3 stainless steel screws in different directions to ensure a firm combination with the tailpipe.2. The rear-sealing design can prevent the exhaust heat from flowing back and burning the bumper;3. Rolled edge, precise fit, no cutting, universal installation;4. The unique drainage hole design can quickly discharge accumulated water and effectively prevent the exhaust pipe from rusting;5. The slant cut appearance gives your car a different style.Specification:Color: Silver, Burnt BlueMaterial: stainless steelInlet ID: 63mm/2.5 Installation method:Screw connection, loosen the screws on the tail pipe and put the tip on the appropriate position of the tail pipe of the car, and then tighten the screws with a wrench. It only takes 5 minutes to do it yourself Notice:1. The distance between the tip and the bumper must be at least 2cm to avoid scalding the bumper due to the high temperature of exhaust gas.2. Please wear gloves when installing, just in case of serious injury.3. When the car has just stopped or started, please do not install this product to avoid being burned by the tail pipe.Note:There may be slight size deviations due to manual measurement, different measuring methods and tools.The picture may not reflect the actual color of the item because of different photographing light, angle and display monitor. 1 X Exhaust Tip [RelatedpruductTemplate] [/RelatedpruductTemplate] Note: Due to the light and screen setting difference, the item's color may be slightly different from the pictures. Please allow slight dimension difference due to different manual measurement.