Color Led Display, Built-In Sound Prompts, Fully Intelligent Flushing, Water Control, Automatic Fault Alarm, Short-Term Automatic Protection. Flushing: 18 Seconds Before Each Water Production; 8 Seconds Every 2 Hours Of Water Production, (The Pump Is Working, The Water Inlet Valve Is Open, The Flushing Valve Is Open, And The Flushing Light Is Flashing)Water Production: When There Is No Shortage Of Water, The Program Detects A Signal That The Water Is Not Full, And Enters The Water Production State; (The Pump Works, The Water Inlet Valve Opens, The Flushing Valve Closes, And The Water Production Light Flashes)Water Full: The Program Detects The Water Full Signal And Enters The Water Full State. (The Pump Stops, The Water Inlet Valve Closes, The Flush Valve Closes, And The Full Water Light Is Always On)Water Shortage: In The Process Of Flushing Or Water Production, The Water Shortage Signal Is Detected, And It Enters The Water Shortage State. (Pump Stopped, Inlet Valve Closed, Flush Valve Closed, Low Water Light Blinking)Maintenance: If The Continuous Water Production Exceeds 6 Hours, It Will Enter The Maintenance State, And The Flushing Valve Will Be Closed. It Can Only Be Recovered By Powering Off And On Again. (The Pump Works, The Water Inlet Valve Opens, The Flushing Valve Closes, And The Flushing, Water Production, And Water Shortage Indicators Flash)Scope Of Application: 400g And 400g Pure Water MachineWorking Voltage:DC 24VInlet Water Pressure: Normal Tap Water PressurePower Consumption: Less than 0.6WWorking Temperature: .20C~+70CWorking Humidity: 5%-85%Screen Size: About 71x30.2mm; Motherboard Size: About 130x61mmColour:blueMaterial:PCBNote:Water Purifier Storage Pump, Can Be Used To Water-128 (400g) Type Of Water Purifier Control Panel.Package Contents:1 x Water Purifier Control Board (English Sticker)1 x 50cm Flex CableOnly the above package content, other products are not included.Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.