[DETAIL] modname=ckeditor Capo 940 is used for jelly gel formation. It can be used as an excellent floatation agent, stabilizer, emulsifier and matrix for pharmaceutical excipients. It is also an effective water-soluble thickening agent. 0.5% of the added amount can make jelly gel with jelly effect, slightly acidic, and the pH value of the dispersed system in 0.5% water is 2.7 - 3.5. Carbo 940, used in jelly gel formation, can be used as an excellent floatation agent, stabilizer, emulsifier and matrix for pharmaceutical excipients. It is also an effective water-soluble thickening agent. 0.5% of the added amount can make jelly gel with jelly effect, slightly acidic, and the pH value of the dispersed system in 0.5% water is 2.7 - 3.5. Kapo 940 is the main raw material for making various kinds of gelatin, that is, jelly gel formation, suitable for making cream, emulsion, and gel. It is also the main material for producing anhydrous hand lotion, hair gel, essence and ice crystal. 1. Weigh 1g carbomer powder in a dry beaker with a scale of 50ml. If there is caking, please grind it with a spoon. 2. Add 25ml of pure water and stir at the same time to make carbomer fully absorb water and dissolve. This step is very critical, you must let the carbomer fully absorb water, generally add water to stir, put a few hours (generally not anxious mm can be configured before going to bed at night, put up the next day will be able to deploy), Carbomer can fully dissolve. If you want to speed up, you can use a water bath to heat. It will be faster to stir while heating. Of course, even if heating can accelerate the process of carbomer's water absorption and swelling, it will take 10-30 minutes. Time. 3. Use the dripping tube to add alkaline solution, stir it side by side, measure pH value, adjust PH7, gel is successful! (use the attached sample for lye) Make up the surplus water. The total volume is about 50ml. The prepared gel base agent can directly mix with other raw materials to prepare all kinds of gel materials. If the concentration of carbomer is less than 0.8%, it is suggested that it should be about 0.5%. [ATTRIBUTES] - Hign-concerned Chemical: None - Origin: Mainland China - Hign-concerned Chemical: None - Origin: Mainland China