Application range: can be applied to the of the materails such as hardware(brass,iron,aluminum,copper,etc.),wood,plastic(ABS,PU,PP,PE,PVC,etc.),stone,ceramic,glass,etc. Applicable industries: autos, electronic products,household appliance,daily arts and crafts,indoor,footwear,sports apparatus,etc. Tensile properties, pattern is not easy deformation. Environment friendly , it will not bring pollution to the natural environment. Not easy to fade; waterproof ; enduring aesthetic appearance. Water transfer film , also called cubic transfer printing, is a way to do the printing on the that is irregular, which overcomes the problem facing offset printing that can not reach the tongued and grooved face. Specification: colour:black Water Operation Temperature: 25-35 Celsius Thickness: 0.03mm Size: 40 x 200cm Pattern:Snakeskin Material:PVA How To Use: Base coating: Mix well the paint obtaining the color that you need. Film selections: Select printing film that you need. Place film: Cut out the fit size, place it flatly on water . Activation: the activator uniformly on the film after placing the film on the water 60-90 seconds. Transfer: Keep 35 degrees, with a fixture alignment film paper uniform downward pressure. Soaking: About . Washing: Remove the remaining film. Drying: Remove the product' water. Storage : The film should be covered by plastic when store. A heavy / dark trash bag is perfect. Film Storage: 18-25 Celsius Optimum Temperature: 21.5 Celsius Humidity: 45-65% Do not open until ready to use to prevent contact with the air. Water Transfer Printing Film is a Hygroscopic Substance. It has the ability of attracting and holding water molecules from the surrounding environment... Do not store near water or in the room where your dip tank is located. Avoid direct sunlight. Package Contents: 1 x Water Transfer Printing Film Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.