This product solves the above problems, and is installed inside the rear of the car, and emits microwaves downward for detection.If the sensor detects an effective kick in the sensing area, it outputs a corresponding level signal according to the signal strength. Control the opening of the tail box.Normal mode: approach the foot of the bumper sensing area and then leave the bumper sensing area. When this action is completed, a trigger signal will be generated.Abnormal patterns: stairs, , branches, rough roads, plastic bottles, car wash, etc., no trigger signal is generated.Type: Trunk Boot Kick SensorFitment Type: Direct InstallBrand new.New high quality products.Installation Notes:1. Find the proper position on the rear guard of the vehicle.2. Wipe the installation position of the sensor.3. off the double-sided tape of the sensor (the side of the double-sided tape is the detection surface) facing the ground4. the sensor firmly to the rear protective plate (inside of the bumper) The sensing surface should avoid metal objects such as iron and aluminum.Second, after -on test, wait for 20 seconds after -on.After the product -test is completed, you can do kicking or sweeping movements under the sensor.1. The sensor can only recognize one action, either kick once or sweep once2, After each action is completed, you need to wait 2 seconds before continuing the operationThird, the product's working characteristics, one kick cannot be used after the car is started, kick is used normally after the is turne.Colour: blackMaterial: plasticPackage Contents:1 Set * Trunk Boot Kick SensorOnly the above package content, other products are not included.Note: Light and different displays may the color of the item in the a little different from the real thing. The measurement allowed error is +/- 1-3cm.