Feature 1Safe and Comfortable Grip Feeling: Made of specially selected high temperature resistant materials, durable and corrosion resistant, providing a safe and comfortable grip feeling 2Textured and Non Slip: The handlebar surface is textured and non slip, providing you with safe driving 3Provide Heat Faster: This elegant motorcycle grip design features a revolutionary heating structure that provides heat faster than ever 4Accurately Adjust Temperature: The five level thermostat allows you to accurately adjust the temperature of the grip and find the best temperature during driving in cold weather conditions 5Energy Saving: Energy saving electric hand special switch, high and low temperature can be adjusted at will, very convenient, safe and energy saving 6For All Motorcycles or ATVs: Allows the user to change the temperature without removing the hand from the handle for safer riding, a universal accessory, suitable for all motorcycles or ATVs, the handlebar diameter is 22mm(7/8in)Item Type: Motorcycle Heated GripsMaterial: TPVColour: BlackInput Voltage: 9-18VWorking Voltage: 12.4-16VProcessing Temperature: Temperature 0-50Power: About 20-40WApplicable Models: 22mm(7/8in) general1. Pour parts cleaning agent or lubricating oil into the middle side of the handle and the grip and shake it back and forth on the grip, then you can pull out the grip and save it for future use, if you no longer need it, you can cut and remove the grip with a knife. Please follow the respective removal methods for metal handles.2. Please pull out the throttle cable from the throttle core before replacing the throttle core in the accessories. If the cable is too hard or pulled hard, it will cause danger. Be sure to pull the cable loosely before pulling it out.3. The cable inside the throttle core is loosened a bit. If the throttle core is replaced, please adjust the tightness of the throttle cable to a proper tightness. When adjusting, make sure that the throttle valve can operate smoothly.4. Apply adhesive on the handle. If it is too thick, it may ooze and cause stains. Please spread the adhesive thinly using a thick cardboard or a scraper, etc., and then insert the grip. There is a hex screw on the controller side, be sure to loosen the screws before inserting, and then tighten them at the end.5. After the power is turned on, the indicator light flashes three times and enters the standby mode (green light flashes-normal, red light flashes less than the operating voltage). The heater has five temperature adjustments. Through the switch control, the light changes from blue to red, and the output will gradually increase at a rate of 20% each time. If the light flashes or goes out, it means that the voltage has dropped and you need to replace the battery or Replace the line. Connection Method: Red connect to positive pole, black connect to negative pole .wang-edit-text{ font-family:'Arial' !important; } .wang-edit-text table { border-top: 1px solid #000; border-left: 1px solid #000; } .wang-edit-text table td, .wang-edit-text table th { border-bottom: 1px solid #000; border-right: 1px solid #000; padding: 3px 5px; } .wang-edit-text table th { text-align: center; }Package List1 Pair of Motorcycle Heated Grips(left and right)4 x Handle Block1 x Handle Wiring1 x User Manual1 x Hex Wrench