Specification: Minimum height: appr. 90MM Maximum height: appr. 360MM Lifting: 2T Material: Steel Net weight: 2KG Scope: Suitable for small and medium sized vehicles. Advantage: A young woman can use a jack alone to support the car tires, which is effortless and takes about one minute Packing include: 1x Scissor jack 1x Handle Attention: 1. Do not exceed rated capacity as designated by the height/capacity curve.(Sea below) 2. Use only on hard level surface. 3. Use for emergency tire changing only. 4. Never get beneath the vehicle when it is supported by the jack. 5. Activate the hazard warning flasher,turn off ignition, set parking brake, move automatic shift selector to park position. In case of a manual transmission, move gear selector into reverse position. In addition, the wheel diagonally opposite from the wheel being lifted shall be chocked in both directions. 6. Lift only on areas of the vehicle as specified by the vehicle manufacturer. 7. Follow tire changing procedure as per the vehicle manufacturer's owner's manual. 8. No alterations shall be made to this product. HEIGHT/CAPACITY CURVE This device is designed to sustain the following loads at these specified heights. DO NOT EXCEED the rated capacity for each position. OPERATIONS 1. Insert the jack handle into the hole of the handle socket. 2. Make sure that the saddle is correctly positioned. To prevent damage to the jack, do not move the jack while the handle is intact in the socket. 3. To raise load, use one hand to hold the front part of the handle and use the other hand to turn at the rear and of the handle clockwise. 4. To lower load, use one hand to hold the front part of the handle and use the other hand to turn at the rear and of the handle counterclockwise slowly.